Automatic Technology Australia Elite Manual de instalación descargar pdf (Pagina 8)

DISENGAGED

DRIVE UNIT INSTALLATION

MOUNTING DRIVE UNIT

1. Mount drive unit using four (4) 10mm loxins or dynabolts.

2. Make sure that the Drive Unit is mounted at an appropriate

height from the ground - allow minimum 35mm clearance for

drive arm extension.

NOTE: If the gateway slopes away from pier/post make sure an

allowance is made for clearance of the drive arm extension and

slave arm to not touch the ground.

MANUAL OPERATION

Disengage drive motor by pulling manual release pin up using the

release ring. While holding the ring, rotate the motor

assembly clockwise. (Fig. 3 & 4)

To re-engage pull pin and rotate motor assembly anti-clockwise

until manual release pin clicks into place.

FIG. 4

FIG. 3

PULL RING TO

DISENGAGE MOTOR

ENGAGED

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sin comentarios

Automatic Technology Australia Elite Manual de instalación Pagina 8