Automatic Technology Australia Elite Manual de instalación descargar pdf (Pagina 5)

FEATURES

Thank you for purchasing the ATA Elite

Swing Gate Opener. This opener is

designed to suit residential hinged swing

gates. The components and materials used

in this opener are of the latest technology

and highest quality. Listed below are some

of the many features.

DUAL LEAF GATE

A dual leaf gate can be controlled with the

addition of a second drive unit. Mains

power is only required for the control box

and a 5-core low voltage cable for the

drive units.

OPERATION

To activate the gate simply press a button

on the remote control transmitter, keypad

or activate any other input device such as

key switch, loop detector, etc. During an

open or close cycle the gate can be stopped

by pressing the button while it is in

motion. The next actuation will move the

gate in the opposite direction.

HOPPING CODE TRANSMITTERS

Every time a button pressed on the

SecuraCode

transmitter a new access

code is generated at random from over

4.29 billion combinations. This greatly

enhances the security of the system and

makes code “grabbing” a thing of the past.

SECURITY CODE STORE

The Elite Swing Gate Opener uses state of

the art technology in storing your selected

transmitter codes. Up to thirty (30)

transmitters can be stored in the opener’s

memory.

ISS (INTELLIGENT SAFETY

OBSTRUCTION SYSTEM)

The opener will automatically reverse if

the gate hits an obstacle or be restricted in

some manner while it is performing a close

cycle. The amount of force the gate should

encounter before reversing is

automatically adjusted by the control

system during the initialisation of the

automatic opener. The gate will also stop if

restricted whilst opening. The Safety

Obstruction Force should be checked at

least once a month.

CONTROLLING INPUTS

The control board has provision for

ancillary controlling inputs including:

open, close, stop, O/S/C, swipe, pedestrian

access and photo-electric (P.E.) safety

beams.

The opener can be triggered by devices

such as swipe card, inductive loop

detector, key switch, hard wired switch,

keypad, etc.

PEDESTRIAN MODE

The gate can be programmed to open

partially to allow pedestrian access. In a

dual leaf gate only one leaf opens to allow

pedestrians through without permitting

vehicle access.

CONTROL OF LOCK AND LIGHTS

The incorporated controller has dedicated

outputs for operating an electric lock and

warning or courtesy lights (with the

addition of a light relay module). The

timing of these outputs can be adjusted to

suit your needs.

PROGRAMMABLE PHOTO

ELECTRIC BEAM INPUT

The PE Beam input can be programmed to

either stop or reverse the gate during a

close cycle. The gate opener can also be

programmed to prevent the gate moving

without the PE first being triggered.

AUTO-CLOSE MODE

The gate can be closed automatically after

preset time. Auto-close mode can be active

for full or pedestrian access or via the

triggered PE input. A PE Beam must be

fitted to use this function.

BATTERY BACKUP AND SOLAR

OPERATION

The opener can be fitted with optional

battery backup or solar chargers to provide

operation during power outages or at

unpowered sites.

GATE SYNC/DELAY

If the gate leafs overlap, a delay can be

used to start one leaf moving without

interfering with the other.

SOFT STOP

The opener slows as the close limit is

approached to reduce the chance of heavy

contact and causing damage to both gate

and opener.

MANUAL OPERATION

The opener can be disengaged and the gate

operated manually by opening the drive

unit cover and disengaging the gearbox. If

power to the opener is disrupted for any

reason it can be disengaged. This will

allow you to manually open or close the

gate.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comentarios a estos manuales

Sin comentarios

Automatic Technology Australia Elite Manual de instalación Pagina 5

Comentarios a estos manuales