Automatic Technology Australia Elite Manual de instalación descargar pdf (Pagina 19)

BATTERY BACK UP

An optional battery backup system is available so that the gate can

be operated (for a limited time) in the event of mains power failure.

When the backup system is utilised, the control board detects the

presence of mains voltage. If mains power fails the control board

switches to the backup supply provided by a 24V DC battery.

When mains power is restored the control board switches back to

mains supply.

The following items are required to use the battery backup system:

1. A 24VDC battery connected to the control board connector

(Fig. 23). ATA order code 90230

2. Ensure a shunt is placed on the VAC pins.

The control board has a built in charger which maintains the

battery charge when mains power is present. The control board

monitors the battery voltage during use and prevents discharging,

which damages the battery, by shutting down the control board if

the battery voltage gets too low.

The 'IN USE' indicator illuminates when mains is not present and

the battery is being used.

The 'VAC' shunt can be removed to prevent the battery system

being used when mains power fails. The battery charge is still

maintained provided mains is present. This link is provided so that

the controller can be turned off when a backup battery is

connected. It is removed when complete absence of power is

required e.g. when clearing the receivers memory.

FIG. 23

SHUNT

IN USE

INDICATOR

24V DC

TERMINAL

OPERATING INSTRUCTIONS

OPERATING THE GATE OPENER - O/S/C

z Press the Button on the Transmitter programmed for full gate

opening for two seconds to open or close the gate.

z Pressing the Transmitter Button again during operation will

cause the gate to stop.

z Pressing the button again will cause the gate to move in the

opposite direction.

OPERATING THE GATE OPENER - PED

z Press the button on the transmitter programmed for pedestrian

access and the gate will open partially. Or in a dual leaf gate

installation - only one leaf will open.

z Press the button again and the gate will close.

When an Auto Close mode selection switch is “ON” the gate will

auto close after 15 – 30 seconds or as triggered by breaking the

P.E. Beam and commencing the timer.

MANUAL OPERATION

z Remove black drive unit cover (key required).

z Disengage drive motor by pulling manual release pin up using

the release ring.

z While holding the ring, rotate the motor assembly clockwise.

To re-engage rotate motor assembly anti-clockwise until manual

release pin clicks into place.

OBSTRUCTION DETECTION SAFETY SYSTEM

If the gate is obstructed while closing it will reverse to the open

position and when the gate is opening the gate will stop.

NOTE: Closing and opening obstruction forces should be

checked regularly and any necessary adjustments made.

CARING FOR TRANSMITTERS

z Do not leave transmitter in direct sunlight

z Do not expose transmitter to excessive heat

z Do not immerse transmitter in water - it is not water resistant.

z Do not subject transmitter to shock or vibration

z Keep transmitter out of reach of children at all times.

ROUTINE MAINTENANCE

ATA recommend to grease all internal drive gears with a high

pressure lubricant at 12 monthly intervals. Failure to provide

routine maintenance will shorten the openers serviceable life.

SERVICE

For on site service and assistance contact your gate/opener

installer or local ATA dealer. They will be able to inspect and

service both your gate and opener. Write the details of your

installer in the space provided on Page 23.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Automatic Technology Australia Elite Manual de instalación Pagina 19

Comentarios a estos manuales