Automatic Technology Australia Elite Manual de instalación descargar pdf (Pagina 20)

TROUBLE SHOOTING

Gate does not open or close Check that power is still available at mains power point.

Check that Control Box is plugged into mains power

Check that motor is engaged for automatic operation.

Check all wiring from motor and microswitches to the control board are sound.

Gate reverses while closing or stops

while opening

Check obstruction overload sensitivity adjustment

Check for obstructions.

Disengage the drive unit to manual and check the gate is in good working order.

If a P.E. beam is fitted ensure it is clear of obstructions or dirt on the lens.

Transmitter not functioning New transmitters must be coded to the receiver.

Check/change the battery in the transmitter (LED flashes to indicate low battery).

Having the antenna behind a structure (gate or fence) or not in line of sight may

reduce optimal range/reception.

Interference from external/outside sources such as baby monitors, or radio transmitter

etc. The best solution is to remove the source causing the interference.

Gate and/or opener requires service Contact the installer of the opener or local ATA dealer for service. They will be able

to inspect, service, adjust or repair the gate and opener as necessary.

SPECIFICATIONS

CONTROL BOX

PROTECTION RATING: IP56

INPUT VOLTAGE: 230V- 240V AC 50Hz

TRANSFORMER PRIMARY VOLTAGE: 230V / 240VAC

SECONDARY VOLTAGE: 24V AC 100 VA

CONTROLLER VOLTAGE: 24V DC

RECEIVER TYPE: UHF 433.92 MHz. AM Receiver

RECEIVER CODE STORAGE CAPACITY: 30 x 4 Button Transmitter Codes

TRANSMITTER FREQUENCY: 433.92 MHz

CODING TYPE: SecuraCode

Hopping Code

No. of CODE COMBINATIONS: Over 4.29 Billion Random Codes

CODE GENERATION: Non-linear Encryption Algorithm

TRANSMITTER BATTERY: A23 Alkaline 12 Volts

DIMENSIONS: 190W x 240H x 100D (mm)

WEIGHT: 4Kg

DRIVE UNIT

MOTOR TYPE: Permanent Magnet Direct Current

MOTOR VOLTAGE: 24V DC

MAXIMUM PULLING FORCE: 200N (20Kg)

DRIVE ARM ROTATION SPEED: approx. 8°/sec

DIMENSIONS: 135W x 290H x 230D (mm)

WEIGHT: 13Kg (incl. arms)

Note:

1. The maximum weight gate that the opener can be installed on 250Kg. The gate must be well balanced. A person of limited strength

should be able to move the gate manually with very little effort (15Kg force max.) in case of an emergency.

2. Intermittent operations may occur in areas which experience very strong wind gusts. A strong wind puts extra pressure on the gate

which may in turn trigger the safety obstruction detection system intermittently.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Automatic Technology Australia Elite Manual de instalación Pagina 20

Comentarios a estos manuales