Automatic Technology Australia Elite Manual de instalación descargar pdf (Pagina 10)

MOUNTING CONTROL BOX

CAUTION: DO NOT USE ANY CABLES WHICH CARRY

GREEN/YELLOW WIRES AS THIS SIGNIFIES EARTH,

AND DOES NOT COMPLY WITH ELECTRICAL

AUTHORITY REGULATIONS.

The control box should be mounted near the drive unit using four

(4) 6mm screws.

1. Drill holes as per (Fig. 8). When locating the control box allow

ample space around the unit for easy access and wiring

connections.

2. Remove cover from control box.

3. Determine which leaf you would like to open first and close

last. This gate leaf must be connected to Motor 1 (M1) terminals

on the control board. Connect drive unit(s) to control board

using 5-core cable. For detailed electrical connection (see

pages 11 & 12).

Note: To determine left or right hand installation stand inside the

driveway. looking out to the street.

ANTENNA

Mount the antenna at or above the height of the gate or fence for

optimal reception, which ever is higher. (Fig. 8). Do not cut

antenna or coaxial cable.

FIG. 8

FIG. 9

LIMITS AND CAMS SET-UP

Setting of limits for open and closed position is performed with

opener in manual position (Fig. 3 & 4).

WARNING: DO NOT SWITCH POWER ON OR ENGAGE

MOTOR DRIVE.

For Right AND Left Hand Side installation:

1. When gate is CLOSED turn TOP cam in a clockwise direction

(Fig. 9) until an audible click can be heard from the TOP

micro-switch.

2. Open the gate to the required OPEN position and turn LOWER

cam in an anticlockwise direction until a click can be heard

from LOWER micro switch.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Automatic Technology Australia Elite Manual de instalación Pagina 10